Noritz 6.6 GPM 40 Gallon Tank 120000 BTU 120V Whole House Tankless Water Heater - LP

Description

From Plumbing Deals' product listing.

Direct Tank Replacement Tankless Water Heater - Liquid Propane The Noritz EZTR40LP (MPN: EZTR40LP) is a 120,000 BTU liquid propane tankless water heater designed to replace standard 40-gallon tank units without re-piping gas or vent lines. Key Features Top-Mounted Water Connections Aligns directly with existing 40-gallon tank water lines, eliminating the need to re-route plumbing during retrofit installations. Flexible B-Vent Retrofit Compatibility Utilizes existing 3-inch or 4-inch B-vent ducting with flexible polypropylene tubing to run through existing metal chimneys up to 420 inches. 1/2-Inch Gas Line Compatible Operates on standard 1/2-inch gas lines up to 24 feet, removing the requirement to pull a new 3/4-inch gas line in most residential applications. High-Efficiency Condensing Technology Delivers a .91 Energy Factor by extracting heat from exhaust gas before venting, featuring an internal condensate management setup. Product Details Maximum Flow Rate: 6.6 GPM Gas Input Range: 15,000 – 120,000 BTU/hr Fuel Type: Liquid Propane (LP) Connections: 3/4" NPT Water, 1/2" NPT Gas Electrical Requirements: 120V / 60Hz with included 6-foot power cord Temperature Range: 115°F – 140°F (120°F factory default) Sizing Guidance: 2-bath homes in southern climates; 1.5-bath homes in northern climates Safety Features: Direct electronic ignition, flame sensor, overheat protection, freeze protection, condensate overfill sensor, and fan rotation detector Included Accessories: Anchoring screws, 6' power cord, owner's manual, warranty documentation, and installation manual Shop all Noritz products Additional Information Brand: Noritz MPN: EZTR40LP Specification Sheet: Download Spec Sheet Installation Manual: Download Installation Guide Noritz EZTR40LP FAQ Can the Noritz EZTR40LP reuse an existing 40-gallon tank vent? Yes. It is engineered to vent directly through existing 3-inch or 4-inch Category I B-vent pipe using flexible polypropylene lining kits up to 420 inches. Does this unit require a 3/4-inch gas line? No. The 120,000 BTU firing rate allows it to operate off a standard 1/2-inch gas supply line for runs up to 24 feet from the main regulator. Where are the water supply connections located? The 3/4-inch water inlets and outlets are positioned on top of the unit, matching the standard drop-in layout of traditional floor-standing tanks. Is a condensate drain required for this model? Yes. Because this is a high-efficiency condensing unit, provision must be made to route acidic condensate to an adequate drain or neutralization system. What electrical service is needed for installation? It requires a standard 120V outlet to power the direct spark ignition, internal controls, freeze protection heaters, and exhaust fan assembly.